Fox-Paws Model 350

$869.95

Applications: Simple shut off for gas or diesel engines controlled by computer/engine module.
The Model 350 can only be plugged into the fuse circuit in the fuse panel that controls the engine.
The Model 350 has been designed to be versatile and user friendly. Besides it's plug-n-go capabilities, it can be configured at the factory with the Model 100,200,225 circuitry. It's receiver can be programmed up to 4 transmitters, making this unit capable of handling up to 90% of all modern mobile applications of shutting off vehicles and equipment.
Ask our sales team how the Model 350 can be configured to meet your safety needs.

Features:

Non-detachable 7-10 foot wire harness.
1-transmitter included in price (optional water resistant enclosure available)
Mounting bracket with magnet.
Expandable up to 4 transmitters

Dimensions:
9.5in. x 4.75 in. x 2.5in.
12 volt D.C. Optional 24 to 12 volt converter available
900 MHZ Frequency
Range 1/4 mile line of sight
Easy plug-n -go system installation.
Green/Run, Red/Stop, Yellow/low Battery indicator.
Weather resistant enclosure (N.E.M.A. 4 )

See details below see how easily the Fox-paws 350 can be installed

Category: Tags:

Description

.Step #1 -Find the fuse in the panel that controls the engine. Pull out this fuse, plug our wire harness into this fuse slot and put the fuse that you pulled out of the panel, back into our wire harness. The computer now is controlled by Fox-Paws with the same protection of the original fuse.

Engine control fuse

Step #1 -Find the fuse in the panel that controls the engine.

 

plug in harness

plug our wire harness into this fuse slot

 

inserting inline fuse

put the fuse that you pulled out of the panel, back into our wire harness

Step# 2 Locate a 4 inch diameter flat spot and stick the mounting bracket magnet to this spot. If the unit is going to be permentely mounted to the vehicle or equipment, the magnet can be removed and bolted with the 2 holes in the bracket.

mounted fox-paws unit

Step# 2 Locate a 4 inch diameter flat spot and stick the mounting bracket magnet to this spot. If the unit is going to be permentely mounted to the vehicle or equipment, the magnet can be removed and bolted with the 2 holes in the bracket.

Step #3 Find a clean ground point and attach the Green ground clamp. If permentely mounted the ground clamp can be removed at the harness connection and the eyelet ring can be attached to the wire harness and the eyelet ring can be bolted to a ground point.

Green grounding clamp

Step #3 Find a clean ground point and attach the Green ground clamp.

 

perminent ground

If permentely mounted the ground clamp can be removed at the harness connection and the eyelet ring can be attached to the wire harness and the eyelet ring can be bolted to a ground point.

.

When installation is complete test unit as described below:
Turn on ignition key, make sure GREEN LED lights on top of Fox-Paws enclosure; if it does not light, make sure the ground is good, if the GREEN still does not light, turn the key to off position, pull wire harness out of fuse panel and turn over and plug back in. Turn key to on position. Fox-Paws GREEN LED should turn on.
To operate unit: Turn on key, start vehicle/equipment. To shut down engine; turn off key or press transmitter. If transmitter is used: turn off key, wait 5 seconds, turn the key back on to restart engine.
If the Model 225 board is used; after transmission, press reset button on top of enclosure.

Reviews

There are no reviews yet.

Be the first to review “Fox-Paws Model 350”

Related products