Description
Installation:
Step #1 -Find the fuse in the panel that controls the engine. Pull out this fuse, plug our wire harness into this fuse slot and put the fuse that you pulled out of the panel, back into our wire harness. The computer now is controlled by Fox-Paws with the same protection of the original fuse.
Step #1 -Find the fuse in the panel that controls the engine.
plug our wire harness into this fuse slot
put the fuse that you pulled out of the panel, back into our wire harness
Step# 2 Locate a 4-inch diameter flat spot and stick the mounting bracket magnet to this spot. If the unit is going to be permanently mounted to the vehicle or equipment, the magnet can be removed and bolted with the 2 holes in the bracket.
Step# 2 Locate a 4 inch diameter flat spot and stick the mounting bracket magnet to this spot.
Step #3 Find a clean ground point and attach the Green ground clamp.
Step #3 Find a clean ground point and attach the Green ground clamp
If the unit is going to be permanently mounted to the vehicle or equipment, the magnet can be removed and bolted with the 2 holes in the bracket.
If permanently mounted the ground clamp can be removed at the harness connection and the eyelet ring can be attached to the wire harness and the eyelet ring can be bolted to a ground point.
.
When the installation is complete test unit as described below:
Turn on the ignition key, make sure GREEN LED lights on top of Fox-Paws enclosure; if it does not light, make sure the ground is good, if the GREEN still does not light, turn the key to off position, pull wire harness out of fuse panel and turn over and plug back in. Turn key to on position. Fox-Paws GREEN LED should turn on.
To operate unit: Turn on key, start vehicle/equipment. To shut down engine; turn off key or press transmitter. If the transmitter is used: turn off key, wait 5 seconds, turn the key back on to restart the engine.
If the Model 225 board is used; after transmission, press reset button on top of the enclosure.
Reviews
There are no reviews yet.